7 1/2 HP drive 20" diameter blade Pneumatically operated Fully automatic operation 11" X 15' conveyor Average cutting speed - 20 FPM 1/2 HP conveyor motor
Mid-Oregon's answer to cutting long lineal endings into short pieces for feeding into waste conveyors, boxes and hogs. An inexpensive answer to a problem which exists in many of today's operations..
4' infeed load space extension Digital readout for quick set-up of length Hopper feed Motorized length adjustment Free standing panel board
Specifications
Broad 18" to 102" length capacity Heavy duty 12" lug spacing (optional spacing available) Sturdy 3 H.P., 3600 RPM Arbor Motor Field proven variable speed hydraulic drive
5-50 lugs per minute Digital readout for quick set-up of length Hopper feed Motorized length adjustment Free standing panel board
All magnetic starters and circuit breakers are located in a cabinet with 120 VAC control transformer and push button controls to each saw motor and drive motor. NOTE: Saw blades are not included.
30 Hp 440/220 volt 6" blowpipe with 1200cfm air flow required at exhaust
Simple rotor and anvil design requires no knife sharpening so operation is virtually maintenance free.
Capacity with Gravity Feed Chute
2" X 4" X 6" max. size or 12" max. length Approximately 80 cu ft. of wood scrap per hour
Power Feed Specifications
8" wide belt conveyor Standard 16' long, 1 hp
Capacity with Power Feed
1-1/2" X 1-1/2" max. cross section of edging 85 fpm feed rate Approximately 80 cu. ft. per hour
Edgings and trim ends can now be economically and simply hogged right at their source, eliminating the need for elaborate conveying systems or the expense of dumping boxes. A large shop may use several mini-hogs at various sources such as the rip saw, finger joint trim backs, trim saw or tennenors. The small shop might use only one unit to serve as a general purpose hog.
Variable hydraulic speed control for fast cutting or precision end trimming Simple design with more cutting capacity Ease of maintenance with complete access to either side of saw 3/4" thick steel center frame Smooth and quiet cutting cycle Adjustable guard for greater safety Anti-repeat cycle for greater safety Complete control panel with starter and disconnect included Can be operated from either side
Specifications
Variable cycle speed: 60 cuts per minute Arbor speed: 3600 rpm Motor: 220V/440V, 3ph60 cycle, 10 hp (15 hp optional) Motor speed: 1750 rpm
Sawdust outlet: 5 inch diameter Cutting Capacity: 4" X 14" or 2" X 19 1/2" Blade Size: 18" diameter, 1 1/8" arbor
Also available with infeed and outfeed rollcases. Call 503-788-4847 for more information.
Maximum Unit Size: 5'-0" square X 16'-0" Minimum Length: 3'-0" Weight: 12,000 lbs. Power: 15 HP hydraulic power supply Voltage: 220/440 VAC AIr: 80 PSI min. 1/4" line min. Size: 23'-0" long X 7'-0" high X 5'-0" wide Cycle: Floor to floor approximately 30 seconds Machine can be used for even end loads of finished moulding for plastic packaging or shipping.
1) Operator places specially stacked load in Glue Bound Unit Breaker machine.
2) Operator activates machine.
3) Platens move in and break glue-bound pieces leaving an even load.
Portland, OR 97202